Background SD Calibration

Brief description of calibrating ALMA single-dish observations

Like any single-dish telescope, ALMA's single dish antennas (nominally, four 12m antennas) detect and quantify brightness temperature ($T_B$, in Kelvin). In the Rayleigh-Jeans approximation, the Planck blackbody law reduces to $T_B=\frac{B\lambda^2}{2k}$.  

An ALMA single-dish observation includes contributions from sky targets in the beam, the telescope surface and receiver equipment, the ground (through reflections), the atmosphere and cosmic background, and any other electronics (necessarily noisy) following the receiver front end. Observations made with a single dish towards a target ($T_{ON}$) are calibrated using an additional observation towards blank sky (i.e. sky at a similar elevation, absent of any target emission at the frequencies of interest to the observer ($T_{OFF}$)).

To determine the signal from the target, we can compute:

$\frac{T_{targ}}{T_{sys}}=\frac{T_{ON}-T_{OFF}}{T_{OFF}}$.   (In CASA, this is accomplished during the "sky calibration" step).

The position of the OFF is made as close as possible (in az/el) to the ON position.  As a practical matter, there may be some differences in the two measurements aside from the target being in the ON position. In most cases, the differences arise chiefly from the atmospheric contribution, though any target coincidentally within the beam of the OFF measurement will contaminate and affect the accuracy of the OFF measurement, and consequently, the measurement of the calibrated brightness temperature of the target.

To calibrate single dish data, we require a measurement of $T_{sys}$, which is done though $T_{atm}$ (i.e. "atmosphere") measurements at the start of each scheduling block.  (In CASA, this is applied through the $T_{sys}$ calibration step.)  $T_{sys}$ determination includes separate observations of the sky, and two "loads" of different, known temperatures.

Note that $T_{sys}(\nu)$ measurements are spectral; that is, they determine $T_{sys}$ as function of frequency. Since they incorporate an observation of the sky, they may include atmospheric features such as the water absorption line in Band 5 at $\sim$183 GHz. So the calibration of the entire band must be done in the frequency domain.

It is policy that ALMA single-dish data must only be observed to supplement and be combined with interferometer observations. Therefore, the single-dish data needs to be converted from its native units of brightness temperature ($T_A^*$) to flux density units (Jy/beam) before combination with the interferometric data. The conversion from $T_A^*$ to Jy/beam is done empirically, and incorporates a factor for forward beam efficiency. The empirical conversion (Jy to K) is computed through mapping observations (done recently in time) of a standard target - either a planet or a quasar - and the scaling from $T_A^*$ to Jy/beam is then made simply and directly from the calibrator map and applied to the science target map. 

Citation Number 1
Citation Text O'Neil, 2002 in "The NAIC/NRAO School on Single Dish Radio Astronomy" C. Salter, et.al eds. (arxiv)
Citation Number 2
Citation Text PdBI mm astro summer school notes (Dutrey, Dutrey & Neri; Guélin)
Citation Number 3
Citation Text Unpublished ALMA memo: Robert Lucas, 2005